Hi Jerry, the 15 MHz is disabled by default, just bridging some pins enables the output: http://syncchannel.blogspot.se/2015/11/denuo-gps-hits-rev-b-dongles.html
If you want to insert some 1PPS signal to discipline it, you need some fake some GPS messages. Dan has done some nice work here, a small ATTiny is sufficient. /Thomas, SA6CID On Tue, Nov 14, 2017 at 08:30:54AM -0800, Jerry Hancock wrote: > Bob, I thought you had to send it code, etc? I have the two units > with cable, etc running upstairs. I want another one for in my office > but the same guy only sells the REF0 and REF1 units separately now > without the cable. I thought about splitting the two and using this > other GPS unit I have (it was one of the TAPR GPS Kits) to send the > other one the 1pps. You’re saying all you need is a plug? I would > need two functioning units. > > Regards, > > Jerry > > > Jerry Hancock > [email protected] > (415) 215-3779 > > > On Nov 14, 2017, at 8:13 AM, Bob Camp <[email protected]> wrote: > > > > Hi > > > > If you are going to get out the soldering iron, why simply make up a plug > > to run the GPS unit stand alone? Keep the second unit powered down > > as a set of spare parts….. Yes, it does depend a bit on what you are doing > > with them …. > > > > Bob > > > >> On Nov 13, 2017, at 11:50 PM, Jerry Hancock <[email protected]> wrote: > >> > >> Anyone have a spare cable for the Lucent setup? I guess I can make one > >> with some DB15 connectors but trying to skip the effort. > >> > >> Thanks > >> > >> Jerry > >> _______________________________________________ > >> time-nuts mailing list -- [email protected] > >> To unsubscribe, go to > >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >> and follow the instructions there. > > > > _______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
