OK, go figure, after resetting the loopback jumpers it came alive with a green light, GPS time is ok, still not presenting a satellite on the LH display but it must be seeing something to have the time correct.
Interesting project all along. > On Nov 15, 2017, at 12:03 PM, Jerry Hancock <[email protected]> wrote: > > I found the write-up on getting 10Mhz out. I added the resistors and cap and > brought it out the 15Mhz connector after separating it from the 15Mhz drive. > > I booted it up and I have a Yellow No GPS light and a Red Fault. The unit > sees the GPS antenna as when I disconnect it the GPS light blinks. I have > the interface plug jumper with 2-8 and 3-13 shorted. I’ve seen others that > say to take 2 and 3 to 8 and I will try that next. I was very careful in the > entire process as it is tough to get the motherboard out of the frame. I am > getting 10Mhz on the 15Mhz TP as expected. This is using the original REF1 > GPS board. > Any ideas? Not seeing any sats on lady heather at all. The antenna is known > to be good. > > Thanks, close but I hope I didn’t do more harm than good. > > Jerry > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
