Hi Luciano --

Thanks for posting that. There's a subtle point about the noise floor that's forever been on my list of things to investigate: the noise floor should be lower in timestamp mode than in time interval (A->B) mode.

That's because in timestamp mode there is jitter contribution only from a single measurement, whereas in time interval mode there is a measurement from each channel so you have two jitter components. So a guess is that the floor should be about sqrt(2) lower in timestamp mode. Someday I will test that theory.

John
----
On 1/8/19 12:38 PM, [email protected] wrote:

    .gif of the TICC noise floor.
    Luciano


    Da "time-nuts" [email protected]
    A [email protected]
    Cc
    Data Tue, 8 Jan 2019 18:31:02 +0100
    Oggetto Re: [time-nuts] Short term 10MHz source

    Hi Paul,
    here the TICC noise floor.
    Regarding the GPS/TICC versus a good Rubidium standard like the HP5065A , 
you cannot apreciate the Rubidium ADEV stability lower than 10Kseconds.
    Luciano


    Da "time-nuts" [email protected]
    A "Discussion of precise time and frequency measurement" 
[email protected]
    Cc
    Data Sat, 5 Jan 2019 12:35:26 -0000
    Oggetto Re: [time-nuts] Short term 10MHz source
    Hi All sorry for a new be question but what is a TICC regards Paul B UK

    -----Original Message-----
    From: time-nuts [mailto:[email protected]] On Behalf Of Chris
    Burford
    Sent: 02 January 2019 03:56
    To: Time Nuts List
    Subject: [time-nuts] Short term 10MHz source

    I have a situation in which I have access to a GPSDO 10MHz source but for
    only about 10-12 hours at a time. My current residence does not allow a
    permanent GPS antenna therefore I am limited in its use.

    I do realise that the long term stability of the GPSDO is somewhat superior
    to a Rubidium source. I'm planning on using my TICC to validate both my
    GPSDO and RFS. I'm aware that such a short "power on" period is somewhat
    counterproductive but I have no other options. I'd like to know if a 6-8
    hour window for the GPSDO is sufficient for use as a 10MHz source for the
    TICC.

    I appreciate any and all comments.

    Regards, Chris
    _______________________________________________
    time-nuts mailing list -- [email protected]
    To unsubscribe, go to
    http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
    and follow the instructions there.


    _______________________________________________
    time-nuts mailing list -- [email protected]
    To unsubscribe, go to 
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
    and follow the instructions there.


_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to 
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.


_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to 
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.

Reply via email to