17/01/2019 14:42
I have a Ublox NEO-M8T-0-10 that in the OE state shows no output on
TP2. If I programme it with the UCentre software for say 500hZ output
I sill see nothing on TP2. Do I need to pull it high on boot or
anything to see an output please? I am not probing it with a X10 scope
probe until after it has booted, so I don't believe it's pulled low on
boot, although I can't see how a X10 probe setting could pull it
anyay. TP0 behaves normally and accepts changes in output frequency.
Otherwise it also seems to generally act correctly. Thanks
Best Regards,
Chris Wilson.
=====================================
Are you sure it's genuine ublox? There are many counterfeits about.
Cheers,
David
--
SatSignal Software - Quality software for you
Web: http://www.satsignal.eu
Email: [email protected]
Twitter: @gm8arv
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
