Hi Michael, But you don't are working with the wrt54gl router, isn't it?
Can you be most explicit with your config?. Sorry if my english isn't very good... Best regards, Ramses > -----Mensaje original----- > De: [email protected] [mailto:[email protected]] En nombre > de Michael Braun > Enviado el: jueves, 18 de marzo de 2010 13:08 > Para: [email protected] > Asunto: Re: Can I pass 802.1q (VLAN tagged) through a VPN Tinc > inHUB/Switchmode?. > > Hi, > > Peter Dey schrieb: > >> The physical config: > >> > >> VLAN1(U)--| Switch Switch |-- > VLAN1(U) > >> VLAN5(T)--|-- Trunk -- TincS-01 ---VPN--- TincS-02 -- Trunk --|-- > VLAN5(T) > >> VLAN10(T)-| Port Port |-- > VLAN10(T) > >> > > > > Note the "Trunk" part. I've never seen a facility under Linux to create > a trunk > > interface (correct me if I'm wrong). > > I've got a setup running where on eth2 there is tagged traffic (multiple > vlans) which is bridged into a tinc tap device. I can create tagged > interfaces (vconfig add) on the other side of the trunk as well as on > the bridge interface. It just works, as long as all dependent interfaces > are configure up explicitly. > > left side of tunnel > > br0 := bridge of eth2 and tap0 > br0.1, br0.2 > > right side of the tunnel > > tap0.1 > > Michael > _______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
