Hi Anil,
I am getting 2 ports(com5 and com6) while connecting MIB520 to pc.
In step 2, I am programming my mote that is connected to Mib520. So while
Programming I have to give lower port(com5). In step 5, I am getting data
from sensors and have to display it in PC.So for communication part I have
to use higher port(com6). This is wht I did earlier.
I also tried your idea.But I am getting following error.
"Can not connect to Mote correctly. Please check your Mote."
Regards,
Dhivya
On Wed, Apr 9, 2008 at 12:47 PM, Anil Karamchandani <[EMAIL PROTECTED]>
wrote:
> Hi Dhivya,
>
> the port number should be the port through which your gateway device is
> connected to the PC. Usually the port number in step 2 and step 5 is the
> same. check for the port which is communicating with the sensor and the PC
> and give that port number ..
>
> hope this helps
>
> anil
>
> On Wed, Apr 9, 2008 at 12:34 PM, Dhivya G <[EMAIL PROTECTED]> wrote:
>
> >
> > Hai,
> > I am using crossbow Professional kit consisting of Micaz motes,MIB520
> > programming board and MTS400 sensor board. I want to know whether I have to
> > program Micaz mote(connected to mib520) to collect data from sensor using
> > Moteview.If so how I have to program Micaz mote.
> > I Connected one micaz mote to mib520 programming board and
> > programmed it using moteconfig as follows:
> > 1) In Moteview I clicked Tools->Program Motes
> > 2)In MoteConfig window I clicked Settings->Interface Board. In Interface
> > board settings window I selected MIB520 and changed com port to 5 (lower
> > port)and clicked Apply.
> > 3)Then I clicked select button under "select file to be uploaded". I
> > selected XMeshBase_2420_hp under C:\Program
> > Files\Crossbow\MoteView\xmesh\micaz\XMeshBase
> > 4)Then I clicked Program button.
> > 5)After finishing program I clicked File->Connect to WSN. In that new
> > window I selected MIB520 board and com6(higher port) and XMTS400 board.
> > 6)After completing all these steps sensor data is not displaying in PC.
> >
> > If my steps are wrong means please correct me.
> > --
> > G.Dhivya
> > _______________________________________________
> > Tinyos-help mailing list
> > [email protected]
> > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
> >
>
>
>
> --
> Regards
>
> Anil Karamchandani
--
G.Dhivya
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
