Add this line to your makefile and remove those macro. 

CFLAGS=-DCC2420_DEF_RFPOWER=3


- Hui

BAI LI wrote:
> I read the cc2420 datasheet and modified it but unluckily it still 
> didn't work. I modified the following code repectivcely.
>  
> #ifndef CC2420_DEF_RFPOWER
> #define CC2420_DEF_RFPOWER          0x1F    // changed the 0x1F to 
> 3 or 1, didn't work.
> #endif
>  
> cheers,
> Bai
> ================================
>  
> On Wed, Dec 17, 2008 at 8:30 AM, Nitin Sharma <[email protected] 
> <mailto:[email protected]>> wrote:
>
>     Hi,
>
>     Could you try setting it to 3 or a little higher instead and see?
>
>     PA_Level 3 Output Power -25 , TXCTRL register 0xA0E3
>
>     The output power is programmable in 8 steps from approximately –24
>     to 0 dBm.
>
>     Page: 9 , 52 from CC2420 Data Sheet.
>
>     Thanks,
>
>     On Tue, Dec 16, 2008 at 2:47 PM, BAI LI <[email protected]
>     <mailto:[email protected]>> wrote:
>
>         Yes, i modified the code. the default value of REPOAWER is 31
>         at the maximum in Tinyos1.15. Then I changed it to 1. I
>         believe nothing changed. The node still can communicate with
>         other nodes at least 15 meters. It is not that good. I will
>         try to use setRFPower. Is this the right value I should change
>         in order to decrease the transimission distance. I am
>         confused. Anyone who has experience, please help me. THanks in
>         advanced.
>
>         On Tue, Dec 16, 2008 at 11:16 AM, Razvan Musaloiu-E.
>         <[email protected] <mailto:[email protected]>> wrote:
>
>             Hi!
>
>
>             On Mon, 15 Dec 2008, BAI LI wrote:
>
>                 Hi All,
>                 Anyone can tell me where to modify the power level in
>                 tinyos 1.x and tinyos
>                 2.x?
>
>
>             In tinyos-2.x you can set the global radio power of CC2420
>             by defining the CC2420_DEF_RFPOWER to a different value or
>             you can change it dynamically on a per-packet basis using
>             the setPower command from the CC2420Packet interface.
>
>             --
>             Razvan ME
>
>
>
>         _______________________________________________
>         Tinyos-help mailing list
>         [email protected]
>         <mailto:[email protected]>
>         
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
>
>
>
>
>     -- 
>     Nitin Sharma
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Tinyos-help mailing list
> [email protected]
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help


_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help

Reply via email to