Hi to all;
I'm using crossbow's MoteConfig software for over the air programming.
The set up I am working on contains two remote motes(with MTS400 sensor boards)
and a base station mode all of which are Micaz.(The Crossbow Starter Kit,
Model:WSN-START2400CA)
I locally installed basestation application (XMeshBase_2420_hp) to the mote
connected to the pc (board interface Mib520)
via Moteconfig and
then switched to the remote program tab.
When I pressed the "Search" button, two remote motes were detected and seen on
the GUI.
But, when I pressed the "Prepare" button; although I saw the message "Node
preparation may take up to 1 minute", the
process is never completed.
What can be the reason of this problem, I exactly carried out the steps
described in MoteConfig User's manual.
I would be so glad if you help me about solution of this problem.
Murat Arslan
Middle East Technical University
Electrical and Electronics Eng. - Senior Student
_________________________________________________________________
News, entertainment and everything you care about at Live.com. Get it now!
http://www.live.com/getstarted.aspx
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
