Couple of things to check: - Make sure you have a battery voltage of at least 2.7V
- Make sure you have checked the boxes next to node IDs before pressing "Prepare" button. Giri ________________________________ From: [email protected] [mailto:[email protected]] On Behalf Of MURAT ARSLAN Sent: Tuesday, February 17, 2009 6:20 AM To: [email protected] Subject: [Tinyos-help] crossbow moteconfig OTAP (for MicaZ) problem Hi to all; I'm using crossbow's MoteConfig software for over the air programming. The set up I am working on contains two remote motes(with MTS400 sensor boards) and a base station mode all of which are Micaz.(The Crossbow Starter Kit, Model:WSN-START2400CA) I locally installed basestation application (XMeshBase_2420_hp) to the mote connected to the pc (board interface Mib520) via Moteconfig and then switched to the remote program tab. When I pressed the "Search" button, two remote motes were detected and seen on the GUI. But, when I pressed the "Prepare" button; although I saw the message "Node preparation may take up to 1 minute", the process is never completed. What can be the reason of this problem, I exactly carried out the steps described in MoteConfig User's manual. I would be so glad if you help me about solution of this problem. Murat Arslan Middle East Technical University Electrical and Electronics Eng. - Seni! or Student ________________________________ Get news, entertainment and everything you care about at Live.com. Check it out! <http://www.live.com/getstarted.aspx%20>
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
