Hi Giri
I am sure that the node battery voltages were higher than 2.7 V and the boxes
were checked.
After all, if the voltages were low or the check boxes were not checked, an
error message appears and process stops immediately.
But, anyway, thanks a lot four your interest and help.
Murat
Subject: RE: [Tinyos-help] crossbow moteconfig OTAP (for MicaZ) problem
Date: Tue, 17 Feb 2009 09:01:36 -0800
From: [email protected]
To: [email protected]
CC: [email protected]
Couple of things to check:
-
Make
sure you have a battery voltage of at least 2.7V
-
Make
sure you have checked the boxes next to node IDs before pressing “Prepare”
button.
Giri
From: [email protected]
[mailto:[email protected]] On Behalf Of MURAT ARSLAN
Sent: Tuesday, February 17, 2009
6:20 AM
To:
[email protected]
Subject: [Tinyos-help] crossbow
moteconfig OTAP (for MicaZ) problem
Hi to all;
I'm using crossbow's MoteConfig software for over the air programming.
The set up I am working on contains two remote motes(with MTS400 sensor boards)
and a base station mode all of which are Micaz.(The Crossbow Starter Kit,
Model:WSN-START2400CA)
I locally installed basestation application (XMeshBase_2420_hp) to the mote
connected to the pc (board interface Mib520)
via Moteconfig and
then switched to the remote program tab.
When I pressed the "Search" button, two remote motes were detected
and seen on the GUI.
But, when I pressed the "Prepare" button; although I saw the message
"Node preparation may take up to 1 minute", the
process is never completed.
What can be the reason of this problem, I exactly carried out the steps
described in MoteConfig User's manual.
I would be so glad if you help me about solution of this problem.
Murat Arslan
Middle East Technical University
Electrical and Electronics Eng.
- Seni! or Student
Get news, entertainment and everything you care about at
Live.com. Check
it out!
_________________________________________________________________
Explore the seven wonders of the world
http://search.msn.com/results.aspx?q=7+wonders+world&mkt=en-US&form=QBRE
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
