Peter, I guess the port you specified is wrong: > xubun...@xubuntos-tinyos:~/Desktop/mikay$ uisp -dprog=mib510 > -dserial=/dev/tty9 --wr_fuse_h=0xd9 -dpart=ATmega128 --w
The mib520 shows up as two serial ports under linux, typically /dev/ttyUSB0 and /dev/ttyUSB1. You need to specify the lower one if you want to program the mote and the higher one to communicate with it. Janos On Thu, Mar 12, 2009 at 8:07 AM, Péter Kókai <[email protected]> wrote: > Thx Kaisen the help! > > But I have a new problem after this! A try this command in the folder > containing the hex file, and I don't get any error message, so this is a > good new! =) > But after this I get this message: Programmer is not responding! > > xubun...@xubuntos-tinyos:~/Desktop/mikay$ uisp -dprog=mib510 > -dserial=/dev/tty9 --wr_fuse_h=0xd9 -dpart=ATmega128 --w > Programmer is not responding. > > I thought that maybe the file format is not good, so I convert the hex file > to .srec file as you wrote! > But the same result! > I tried to change the port: I use the com10 and com11: I tried both of them, > but the same result I got! > Can somebody help me to find the solution? > I'm starter in these things: tinyos, micaz and mib520! > > Thanks > Peter Kokai > > > > > 2009/3/11 Kaisen Lin <[email protected]> >> >> You need the uisp program, and the command is: >> >> uisp -dprog=mib510 -dserial=/dev/ttyUSB0 --wr_fuse_h=0xd9 -dpart=ATmega128 >> --w >> r_fuse_e=ff --erase --upload if=main.srec --verify >> >> Make sure you to check what your USB port is. There are two (one for >> programming, one for communication, use the first one). The file in this >> case is main.srec. Your hex file might work, but I'm not 100% sure. You can >> try it. If not, just convert it to an srec. >> >> Kaisen >> >> ----- "Péter Kókai" <[email protected]> wrote: >> >> > Hi all! >> > >> > I have a micaz mote, and a MIB520 programming board! >> > And my problem is, that I have a program what was write with AVRStudio >> > 4 in Assembly, cause I have to use this language. It generated a .hex >> > file! And I should upload this file to the mote! >> > I thought that I can do this with tinyOS, but I couldn't! I tried to >> > figure out a solution but I wasn't successful yet! >> > Is there any chance to do this with TinyOs? To upload a .hex file to >> > the mote? >> > >> > Thanks & Regard >> > Peter Kokai >> > _______________________________________________ >> > Tinyos-help mailing list >> > [email protected] >> > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > > > > -- > Üdv: Kókai > ___ > Have a Nice Night!!! > > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
