Hi,
This is Praveen and i am doing PhD in Oklahoma state university.
I was not able to install the FT2232C driver on XUBUNTOS machine.
I am not able tp program Micaz using MIB520.
when i try to make micaz install i see following error.
The device is not recognized.
make micaz install mib510,/dev/ttyS0
mkdir -p build/micaz
compiling BlinkAppC to a micaz binary
ncc -o build/micaz/main.exe -Os -fnesc-separator=__ -Wall -Wshadow
-Wnesc-all -target=micaz -fnesc-cfile=build/micaz/app.c -board=micasb
-DDEFINED_TOS_AM_GROUP=0x22 --param max-inline-insns-single=100000
-DIDENT_APPNAME=\"BlinkAppC\" -DIDENT_USERNAME=\"praveen\"
-DIDENT_HOSTNAME=\"praveen-laptop\" -DIDENT_USERHASH=0x0fa84db1L
-DIDENT_TIMESTAMP=0x4a971fa5L -DIDENT_UIDHASH=0xd90a9f1eL -fnesc-dump=wiring
-fnesc-dump='interfaces(!abstract())' -fnesc-dump='referenced(interfacedefs,
components)' -fnesc-dumpfile=build/micaz/wiring-check.xml BlinkAppC.nc -lm
compiled BlinkAppC to build/micaz/main.exe
2052 bytes in ROM
51 bytes in RAM
avr-objcopy --output-target=srec build/micaz/main.exe build/micaz/main.srec
avr-objcopy --output-target=ihex build/micaz/main.exe build/micaz/main.ihex
writing TOS image
cp build/micaz/main.srec build/micaz/main.srec.out
installing micaz binary using mib510
uisp -dprog=mib510 -dserial=/dev/ttyS0 --wr_fuse_h=0xd9 -dpart=ATmega128
--wr_fuse_e=ff --erase --upload if=build/micaz/main.srec.out --verify
Programmer is not responding.
make: *** [program] Error 2
Can you suggest how can i use mib520 in XUBUNTOS
Thanks.
--
View this message in context:
http://www.nabble.com/Mib520-FT2232C-driver-installation-tp25182815p25182815.html
Sent from the TinyOS - Help mailing list archive at Nabble.com.
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
