Hi all, I'm using Crossbow MICAZ devices for some experiments with MTS400 and MDA300/320 Sensor Board. Crossbow provides driver for both sensor boards, for MTS400 provides both a high power (HP) and low power (LP) driver(firmware). If I use the HP driver I can change data sending rate through a command on moteview but if I use LP I can't. Why? Is there no way to solve this problem? Does anyone know how to solve the dilemma? I would like to receive an huge quantity of data only after my command (increase in data rate) otherwise normally the motes have to transmit every x minutes (low data rate) in low power mode. Each proposal will be very appreciate. TNX Denis
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
