What software are you using? Low-power nodes that are sleeping may not wakeup to get a message from the host. I found under Moteworks that they seem to get host messages, but only if they are specifically addressed to the recipient MoteID, not BCAST.
MS Denis Smorgon wrote: > Hi all, > > I'm using Crossbow MICAZ devices for some experiments with MTS400 and > MDA300/320 Sensor Board. > Crossbow provides driver for both sensor boards, for MTS400 provides > both a high power (HP) and low power (LP) driver(firmware). > > If I use the HP driver I can change data sending rate through a command > on moteview but if I use LP I can't. Why? Is there no way to solve this > problem? > > Does anyone know how to solve the dilemma? I would like to receive an > huge quantity of data only after my command (increase in data rate) > otherwise normally the motes have to transmit every x minutes (low data > rate) in low power mode. > > Each proposal will be very appreciate. > > TNX > > Denis > > > ------------------------------------------------------------------------ > > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
