I'm using Moteview. I tryed to send a message (Set data rate) to an unique MoteID but the mote doesn't change data rate. If I send "wake" command through xserveterm then the mote sends just one data packet but afterward it sleeps again.
I don't know how I can proceed!!! DS -----Messaggio originale----- Da: Michael Schippling [mailto:[email protected]] Inviato: giovedì 10 settembre 2009 23.13 A: Denis Smorgon Cc: 'tinyos forum' Oggetto: Re: [Tinyos-help] Some problem with Crossbow mts400 and data rate in low power mode What software are you using? Low-power nodes that are sleeping may not wakeup to get a message from the host. I found under Moteworks that they seem to get host messages, but only if they are specifically addressed to the recipient MoteID, not BCAST. MS Denis Smorgon wrote: > Hi all, > > I'm using Crossbow MICAZ devices for some experiments with MTS400 and > MDA300/320 Sensor Board. > Crossbow provides driver for both sensor boards, for MTS400 provides > both a high power (HP) and low power (LP) driver(firmware). > > If I use the HP driver I can change data sending rate through a command > on moteview but if I use LP I can't. Why? Is there no way to solve this > problem? > > Does anyone know how to solve the dilemma? I would like to receive an > huge quantity of data only after my command (increase in data rate) > otherwise normally the motes have to transmit every x minutes (low data > rate) in low power mode. > > Each proposal will be very appreciate. > > TNX > > Denis > > > ------------------------------------------------------------------------ > > _______________________________________________ > Tinyos-help mailing list > [email protected] > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
