Tom Oehser <[EMAIL PROTECTED]> writes:
> You probably have a bad clone NE2000 network card? I have seen problems
> with those. You can enter the parameters for it at boot, that is, if it
> was on port 0x300 irq 10, it would be something like:
>
> boot: zImage eth0 iport=0x300 irq=10
>
> (I probably have the syntax wrong, look in the BootPrompt howto...)
Sure enough. It took a couple of tries to get the syntax right, but it
works. What I finally came up with is:
boot: zImage ether=9,0x300,eth0
Thanks for the prompt response.
--
Bud Rogers <[EMAIL PROTECTED]> http://www.sirinet.net/~budr/zamm.html
