OK well I hate to send it back but it just does not seem to recieve much of 
anything. Typical project the NUVI 350 I purchased arrived they sent a 360 
instead, power supply I purchased smoked and blew a fuse the first time I fired 
it up, just do not know when the fun will end.

Thanks for taking a look at it I am not ruling out that it is something I did 
wrong, just cannot imagine what it is.

Thanks Again Scott


 In [email protected], Scott Miller <sc...@...> wrote:
>
> Nothing easy comes to mind, unless you've got a service monitor.  If you 
> want to send it back I'll try it out at low signal levels.  That's not 
> part of my normal test procedure since it's supposed to be tested at the 
> Friendcom factory.  I just do a data decode test at -60 dBm with varying 
> amounts of noise.
> 
> Scott
> 
> w6cjq wrote:
> > 
> > 
> > 
> > Hi Scott: Any other diagnostic I could run on this ?
> > 
> > In [email protected] <mailto:tracker2%40yahoogroups.com>, Scott 
> > Miller <scott@> wrote:
> >  >
> >  > No, the T2-301 never had that problem. Could be the receiver itself has
> >  > a sensitivity problem.
> >  >
> >  > Scott
> >  >
> >  >
> >  > Yono Adisoemarta wrote:
> >  > >
> >  > >
> >  > >
> >  > >
> >  > > That T2 board might still has the "deaf syndrome" due to wrong R and C
> >  > > during mfg ?
> >  > >
> >  > > Paulus N5SNN
> >  > >
> >  > > Sent from my iPhone
> >  > >
> >  > > On Jul 11, 2009, at 9:09 AM, "w6cjq" <w6cjq@
> >  > > <mailto:w6cjq%40yahoo.com>> wrote:
> >  > >
> >  > > So I had a chance to compare things I connected a sound card interface
> >  > > to a FT8800 a VX 150HT to a MFJ TNC and the T2 301 The T2 decoded the
> >  > > fewest amount about 50 % less than the sound card and about 40 % less
> >  > > than the MFJ TNC set up. I live in an area where the signal comes off
> >  > > the top of a 3600 ASL hill and gives you a full scale reading on the
> >  > > radios so I have lots of signal to play with, just have a hard time
> >  > > believing the T2 reciever is really not working that well, must be a
> >  > > setting in this thing somewhere. ---
> >  > >
> >  > > In [email protected] <mailto:tracker2%40yahoogroups.com> 
> > <mailto:tracker2%40yahoogroups.com>, "Lynn
> >  > > W. Deffenbaugh (Mr)" <ldeffenb@> wrote:
> >  > >
> >  > > In my experience, it is unfair to compare a hardware TNC with a sound
> >  > > card interface. The sound card seems to be able to decode a much
> >  > > broader range of signals than the hardware TNCs. This is based on
> >  > > KPC-3+, TinyTrak4, and T2-135 hardware TNCs. Once the radio levels are
> >  > > tuned well, the TT4 and T2-135 (v1.2 only) can come close to what I was
> >  > > getting from AGWPEpro, but the sound card still consistently decoded
> >  > > 10-25% more packets even when fed by the same radio via an audio Y 
> > cable.
> >  > >
> >  > > That being said, I've still retired the sound card system and am 
> > using a
> >  > > TinyTrak 4 as my IGate (KJ4ERJ-2/-7) and T2-135s with Nuvi 350s as my
> >  > > trackers (KJ4ERJ-9 and KJ4ERJ-14). I just couldn't justify the overhead
> >  > > of keeping a windows PC alive and WIRED to a radio connected to an
> >  > > antenna on a tower in the lightning capital of the world (Florida).
> >  > > With the TT4, I'm using a Bluetooth to serial connection between 
> > the TNC
> >  > > and the javAPRSsrvr server so there's an ultimate air-gap 
> > protection there.
> >  > >
> >  > > Your mileage may vary, but the DSP power of a computer with sound card
> >  > > was always better in my experience.
> >  > >
> >  > > Lynn (D) - KJ4ERJ
> >  > >
> >  > > w6cjq wrote:
> >  > >
> >  > > Hi so I am a proud new owner of a T2-301 Prior to this I was using a
> >  > > west mountian sound card interface with a FT8800. So here is what I
> >  > > have noticed. I set the T2-301 up and got it talking through the com
> >  > > port on my computer. I use Ui View 32 and noticed that I was not
> >  > > seeing a lot of traffic. I turned on my HT and heard a lot of traffic
> >  > > on 144.39 but the T2-301 only seems to pass about every 5th or so
> >  > > transmission to UI-View 32. The stations do show up on the map and I
> >  > > can transmit a query through the T2-301 it just seems to be real
> >  > > selective about what it here and sends to the com port.
> >  > >
> >  > > I also monitored the unit in hyper terminal and the same amount of
> >  > > traffic appeared
> >  > >
> >  > > Any thoughts on this??
> >  > >
> >  > > ------------------------------------
> >  > >
> >  > > Yahoo! Groups Links
> >  > >
> >  > >
> >  >
> > 
> >
>


Reply via email to