Okay, time to play some more... I'm looking to add some telemetry to the OT2, and need to play a bit to figure things out...
>From previous posts: >I could not get ADC1 beeing reported. In some earlier documentation > I found the standard telemetry packet of OT2m mentioned to be >T#,internalTemperature,SupplyVoltage,ADC0_Pin10,COUNTER_Pin6,HDOP_GPS,000000,Jumper,Profile Scott Miller <sc...@...> wrote: > I missed this before... here's the pinout for the 16 pads at the front, > starting at the 'M' in MON08: > > 1 - PTB7/T2CH1 (digital I/O or timer channel) > 2 - GND > 3 - PTB5/T1CH1 > 4 - Reset > 5 - No connection > 6 - IRQ (counter/transmit-now input) > 7 - No connection > 8 - PTA3/ADC3 (digital I/O or ADC input) > 9 - No connection > 10 - PTA0/ADC0 > 11 - No connection > 12 - PTA2/ADC2 > 13 - Clock oscillator (32.768 kHz) > 14 - PTA1/ADC1 > 15 - +5V > 16 - PTB0 (digital I/O) So, my thoughts are to play around a bit and see what I can get figured out. What I'd like to do, is to have the OT2 here on the bench, and have a computer connected to it, and be able to monitor what it sees for telemetry input values. The tuning and diagnostics page shows the values for PTA6 (Voltage), and PTA7 (Temperature), but is there a way to monitor other values that can be reported in the telemetry? I'd like to be able to see if my fiddling around changes the values reported by ADC0_Pin10 and COUNTER_Pin6, as well as the Profile Select Jumper. I can set the unit up to report telemetry with every transmission, set the reporting rate very high, connect a radio, and then monitor what I'm sending with another TNC/radio/computer. I can also send the packets to the network, and watch the digipeats come back, but I don't want to disturb others with my experiments. Is there a way I can the packets I am trying to send out on the local console? That would do it, but I can't seem to find a a way to get them on my screen. James VE6SRV
