I have been very successful in setting up a T2-135 fillin digi. If you would like I could get a display of all the settings and send them to you. We are in a bit of a remote area and I need to do a wide 2 to get into a Igate. With just a couple of edits you could put the command list into your T2 and see if it works. Would be glad to work with you off list and then you could report back to the list on your success.
seven three de NB7O/Kevin --- In [email protected], "Tim Cunningham" <tim_cunning...@...> wrote: > > Under the 2005 APRS Paradigm change you should not support WIDE3 paths > unless absolutely necessary (region dependent) . Thus, the following > settings should be employed to conform to the 2005 APRS Paradigm scheme: > > ALIAS 1 WIDE > HOPLIMIT 1 2 > DIGIID 1 ON > USEALIAS 1 ON > > The above settings support WIDEN-n paths. > > > If your goal is only to support a WIDE1 fill-in digi the following should > work for you: > > ALIAS 1 WIDE1 > HOPLIMIT 1 1 > DIGIID 1 ON > USEALIAS 1 ON > > > These settings work in our network where we have 8 (DR-135T / T2-135) > systems providing weather station coverage along with WIDEn-n and WIDE1-1 > support in an adjacent county. > > > > 73's, > > Tim - N8DEU > Decatur, Alabama > > > > > > > ----- Original Message ----- > From: "M & M Neno" <ne...@...> > To: <[email protected]> > Sent: Thursday, May 20, 2010 2:58 AM > Subject: Re: {Disarmed} [tracker2] SET UP DIGIPEATER ???HELP PLEASE > > > Same here, for some reason I am unable to get it, T2-135, to respond to > WIDE1-1, but it will do the > opposite & digi all the other wides, that is opposite to what I want, a fill > in digi. > I have played with cmd hoplimit till I am blue in the face & it appears that > the numbers have no correlation > to WIDE as we know it. It appears to take WIDE with no numbers as being 1 > hop, so HOPLIMIT 1:1 means > it will digi on wide alone,BUT if we leave that as 1:0, no hops, & go to 2:1 > it still ignores WIDE1-1 & decrements > WIDE2-1 to zero, bloody confusing AY. > The best I have at present is HOPLIMIT 2:2 with all the others set to :zero. > I plan to reload firmware next time I am at digi site to see if that helps. > Frankly, if I had known it was going to > be this much trouble I would not have bothered with it, the old baycom modem > hooked up to a crappy old > AT 200 PC using UI-view as a digi worked much better, this was supposed to > be an upgrade but is a flop. > > 73, Murray, ZL1ARL. > > > ----- Original Message ----- > From: Mahendra > To: [email protected] > Sent: Wednesday, May 19, 2010 9:06 PM > Subject: {Disarmed} [tracker2] SET UP DIGIPEATER ???HELP PLEASE > > Hi All > I have the OT2M , wanted to setup as digipeater. > how to setup for aliases , I did try > WIDE1 WITH HOPS 1 > WIDE2 HOPS 2 > WIDE3 HOPS 3 > > DIGI ON. > > Seem to me not digipeated mobile station. > Please help...THANKS+ >
