************* The following message is relayed to you by [email protected] ************ 1 - I want to make sure that the proper way to run RI is as shown below
a-5-a-4-a-6-a-8-a-2-a-8-a-1-a-1-a-0 b-8-b-1-b-1-b-0 a-4-a-6-a-0 b-6-b-2-b-7-b-1-b-0 And Not: a-5-a-4-a-6-a-8-a-2-a-8-a-1-a-1-a-0 b-8-b-1-b-1-b-0 a-b-5-a-b-2-a-b-4-a-b-9-a-b-5-a-b-0 The numbers represent amount of change, so when change is zero, you EP. 'a' represents running 'Create something' 'b' represents running 'Have someone else create something' So I am basically saying that the final step does involve interspersing commands 'a' and 'b', but repeating 'a' and 'b' once more after doing them once. Now, I am about to get a Stalker e-meter and am assuming that the 'change' that Dennis refers to can be measured there? And, without a meter, how would one detect 'change' when one is following commands a and b. And finally, for those for whom none of the 3 command sets produce change, Dennis suggests a simpler exercise of touching walls and floors and tables until they produce no 'change' --- I find these instructions very odd. I just touched my table twice and it seemed the same both times to me. In other words there was no change between the two times I touched it from what I could tell. Just by way of association, I know of a different Freezone exercise at http://SoloProcessing.EU where you pay attention to a mass on your body until it dissolves. And until it dissolves, the meter will show some sort of reading. _______________________________________________ Trom mailing list [email protected] http://lists.newciv.org/mailman/listinfo/trom
