-Jason
i installed the tdk in a normal way, but i am missing the notes how to
install
turbine independent of the supplied tomcat 4.0 engine.
Can you point me in the direction how i should setup turbine on a clean
engine ?
Greetz,
Marco
-----Original Message-----
From: Jason van Zyl [mailto:[EMAIL PROTECTED]]
Sent: maandag 17 september 2001 14:45
To: [EMAIL PROTECTED]
Subject: Re: starting with turbine 2.x a good idea ?
On 9/17/01 8:16 AM, "Marco Pas" <[EMAIL PROTECTED]> wrote:
> Hi,
>
> just wanted to hear some opinions..
> I want to start with a framework like Turbine but i am getting a little
> concerned that my effort
> in learning 2.x is going to be lossed ?
Why do you think your the effort put in to learning 2.x will be lost?
Turbine 3.0 is undoubtedly different internally, no question, but your pull
tools, modules and templates will all work in Turbine 3.0. If you stick to
the use of pull tools in your templates than the impact should be minimal.
Your module source will require some modification but in most cases a
migration tool will take care of that for you.
> Should i wait until 3.x arrives or
> move to another framework ?
I wouldn't recommend either, I would use 2.x and migrate to 3.x when it is
released.
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [EMAIL PROTECTED]
> For additional commands, e-mail: [EMAIL PROTECTED]
--
jvz.
Jason van Zyl
http://tambora.zenplex.org
http://jakarta.apache.org/turbine
http://jakarta.apache.org/velocity
http://jakarta.apache.org/alexandria
http://jakarta.apache.org/commons
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
