Dear Ramji PanchaReddy, in message <[EMAIL PROTECTED]> you wrote: > > I am using BMW board. > i used Sandpoint8245_config for board configuration based on the CPU > when i load the u-boot.bin i got following o/p ... > FLASH: *** failed *** > ### ERROR ### Please RESET the board ###
Well, what did you expect when you configure for board "A" and run on board "B"? > 1.Did i configured u-boot correctly for my board.If so what else i have to > do to boot the board smoothly. If you really have a "BMW" Board then you must configure U-Boot for the "BMW" board. Any other board configuration cannot work. > 2.which cross compiler i have to use to compile this and where can we get > it? You can for example use the ELDK. See http://www.denx.de/wiki/view/DULG/ELDKAvailability Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] This restaurant was advertising breakfast any time. So I ordered french toast in the renaissance. - Steven Wright, comedian _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
