Hi Wolfgang, Thanks a lot for your response .. I also tried BMW_config and used cross-compiler as ppc_82xx-* .When i load this i did not get any thing on console. My processor is MPC8245.
Regards, Ramji On Wed, Sep 3, 2008 at 8:29 PM, Wolfgang Denk <[EMAIL PROTECTED]> wrote: > Dear Ramji PanchaReddy, > > in message <[EMAIL PROTECTED]> > you wrote: > > > > I am using BMW board. > > i used Sandpoint8245_config for board configuration based on the CPU > > when i load the u-boot.bin i got following o/p > ... > > FLASH: *** failed *** > > ### ERROR ### Please RESET the board ### > > Well, what did you expect when you configure for board "A" and run on > board "B"? > > > 1.Did i configured u-boot correctly for my board.If so what else i have > to > > do to boot the board smoothly. > > If you really have a "BMW" Board then you must configure U-Boot for > the "BMW" board. Any other board configuration cannot work. > > > 2.which cross compiler i have to use to compile this and where can we get > > it? > > You can for example use the ELDK. See > http://www.denx.de/wiki/view/DULG/ELDKAvailability > > Best regards, > > Wolfgang Denk > > -- > DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] > This restaurant was advertising breakfast any time. So I ordered > french toast in the renaissance. - Steven Wright, comedian >
_______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
