Hi, Max

[email protected] wrote:
> Hello,
>
> I've encountered the same problem and found a solution.
> In 
> drivers/pci/pci_indirect.c, add the following code block at line 79:
>
> #elif 
> defined(CONFIG_460EX)
> #define INDIRECT_PCI_OP(rw, size, type, op, mask)                      \
>
> static int                                                             \
> indirect_##rw##_config_##size(struct pci_controller *hose,    
>        \
>                             pci_dev_t dev, int offset, type val)       \
> {                                                                      \
>       u32 b, d,f;             
>                                        \
>       b = PCI_BUS(dev); d = PCI_DEV(dev); f = PCI_FUNC(dev);           \
>       b = b - 
> hose->first_busno;                                     \
>       dev = PCI_BDF(b, d, f);                                          \
>       if (PCI_BUS(dev) > 
> 0)                                            \
>               out_le32(hose->cfg_addr, dev 
> | (offset & 0xfc) | 0x00000001); \
>       
> else                                                             \
>               out_le32
> (hose->cfg_addr, dev | (offset & 0xfc) | 0x00000000); \
>       cfg_##rw(val, hose-
>   
>> cfg_data + (offset & mask), type, op);        \
>>     
>       return 0;                                                        \
> }
> #else
>
> Hope 
> this helps
>
> Ciao
>
> Max Tretene, ACube Systems Srl
>   
Thanks for help. Your fix indeed helps to avoid infinite loop I had.
u-boot still hangs for me, now at different place:

U-Boot 2009.11 (Dec 24 2009 - 16:12:11)

CPU:   AMCC PowerPC 460EX Rev. A at 600 MHz (PLB=200 OPB=100 EBC=100)
       Security/Kasumi support
       Bootstrap Option H - Boot ROM Location I2C (Addr 0x52)
       Internal PCI arbiter enabled
       32 kB I-Cache 32 kB D-Cache
Board: Canyonlands - AMCC PPC460EX Evaluation Board, 2*PCIe, Rev. 14
I2C:   ready
DRAM:  512 MB (ECC not enabled, 400 MHz, CL3)
FLASH: 64 MB
NAND:  256 MiB
PCI:   Bus Dev VenId DevId Class Int
PCI Autoconfig: Bus Memory region: [0x80000000-0x8fffffff],
                Physical Memory [80000000-8fffffffx]
PCI Autoconfig: Bus I/O region: [0x0-0xffff],
                Physical Memory: [d8000000-d800ffff]
PCI Scan: Found Bus 0, Device 6, Function 0
PCI Autoconfig: Found P2P bridge, device 6

The hang is at

pci_hose_read_config_byte(hose, dev, PCI_HEADER_TYPE, &header_type);

invoked from pci_hose_scan_bus().

Any ideas ?

Thanks a lot.

Felix.
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to