Hi Stefano On Fri, 2019-04-26 at 09:37 +0000, [email protected] wrote: > > Add i.MX8QM MEK board support. > > Included a basic dts, enabled SPL FIT > > Boot log as below: > > U-Boot SPL 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 > > +0800) > > Normal Boot > > Trying to boot from MMC2_2 > > U-Boot 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 +0800) > > CPU: NXP i.MX8QM RevB A53 at 142933 MHz > > Model: Freescale i.MX8QM MEK > > Board: iMX8QM MEK > > Build: SCFW 9330215b > > Boot: SD1 > > DRAM: 6 GiB > > MMC: FSL_SDHC: 0, FSL_SDHC: 1 > > Loading Environment from MMC... *** Warning - bad CRC, using > > default environment > > In: serial@5a060000 > > Out: serial@5a060000 > > Err: serial@5a060000 > > Net: > > Error: ethernet@5b040000 address not set. > > eth-1: ethernet@5b040000 > > Hit any key to stop autoboot: 0 > > Signed-off-by: Peng Fan <[email protected]> > > Applied to u-boot-imx, master, thanks !
This one introduced a superfluous trailing line continuation in the Makefile: https://git.denx.de/?p=u-boot/u-boot-imx.git;a=commitdiff;h=0d331c035a091c1c1af4180b40bd234e3b87e80a#patch1 I will fix this and also make sure stuff is alphabetically sorted again in my updated Colibri iMX8X introduction patch. OK? > Best regards, > Stefano Babic Cheers Marcel _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
