On 26/04/19 12:50, Marcel Ziswiler wrote: > Hi Stefano > > On Fri, 2019-04-26 at 09:37 +0000, [email protected] wrote: >>> Add i.MX8QM MEK board support. >>> Included a basic dts, enabled SPL FIT >>> Boot log as below: >>> U-Boot SPL 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 >>> +0800) >>> Normal Boot >>> Trying to boot from MMC2_2 >>> U-Boot 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 +0800) >>> CPU: NXP i.MX8QM RevB A53 at 142933 MHz >>> Model: Freescale i.MX8QM MEK >>> Board: iMX8QM MEK >>> Build: SCFW 9330215b >>> Boot: SD1 >>> DRAM: 6 GiB >>> MMC: FSL_SDHC: 0, FSL_SDHC: 1 >>> Loading Environment from MMC... *** Warning - bad CRC, using >>> default environment >>> In: serial@5a060000 >>> Out: serial@5a060000 >>> Err: serial@5a060000 >>> Net: >>> Error: ethernet@5b040000 address not set. >>> eth-1: ethernet@5b040000 >>> Hit any key to stop autoboot: 0 >>> Signed-off-by: Peng Fan <[email protected]> >> >> Applied to u-boot-imx, master, thanks ! > > This one introduced a superfluous trailing line continuation in the > Makefile: > > https://git.denx.de/?p=u-boot/u-boot-imx.git;a=commitdiff;h=0d331c035a091c1c1af4180b40bd234e3b87e80a#patch1 > > I will fix this and also make sure stuff is alphabetically sorted again > in my updated Colibri iMX8X introduction patch. OK?
That's fine, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] ===================================================================== _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
