On Mon, Oct 3, 2022 at 9:50 AM Fabio Estevam <[email protected]> wrote: > > On Mon, Oct 3, 2022 at 1:26 PM Fabio Estevam <[email protected]> wrote: > > > And 'dm tree' shows that the Ethernet drivers have not been probed: > > > > => dm tree > > > > ethernet 0 [ ] fecmxc | | `-- > > ethernet@30be0000 > > ... > > mdio 0 [ ] fec_mdio | | `-- mdio > > This was an issue in Kconfig. Now with the new mv88e6xxx driver > properly selected I get: > > SEC0: RNG instantiated > Net: > Error: ethernet@30be0000 address not set. > Error: ethernet@30be0000 address not set. > Error: ethernet@30be0000 address not set. > Error: ethernet@30be0000 address not set. > Error: ethernet@30be0000 address not > ... > > and not able to access console as these errors keep coming in loop.
Fabio, Looks like this is coming from net/eth-uclass.c with CONFIG_NET_RANDOM_ETHADDR not defined and would be because there is no ethaddr env to set the MAC addr? If I undefine ethaddr on my board and define CONFIG_NET_RANDOM_ETHADDR=y I get an random MAC that is the same for all ports and DHCP/networking works but if I then disable CONFIG_NET_RANDOM_ETHADDR I see the same behavior as you - so it looks like the lack of a valid MAC addr causes eth_post_probe() to fail by design? Tim
