On Thu, Aug 04, 2011 at 04:42:51AM -0700, Prafulla Wadaskar wrote: > > > > -----Original Message----- > > From: Jason [mailto:[email protected]] > > Sent: Tuesday, August 02, 2011 6:34 PM > > To: [email protected]; Prafulla Wadaskar > > Cc: [email protected]; [email protected]; Prabhanjan Sarnaik; Ashish > > Karkare; Siddarth Gore; [email protected]; [email protected] > > Subject: Re: [PATCH v2] arm/kirkwood: print speeds with cpu info. > > > > Wolfgang, > > > > On Mon, Aug 01, 2011 at 01:04:27AM +0000, Jason Cooper wrote: > > > If CONFIG_DISPLAY_CPUINFO is enabled on kirkwood SoCs, this will print > > the > > > speeds of the various components. > > > > > > Signed-off-by: Jason Cooper <[email protected]> > > > --- > > > Changes since v1: > > > - optimized macros to remove one-timers > > > - reduced switch/case to if/else since it operates on one bit. > > > - remove RFC > > > > > > arch/arm/cpu/arm926ejs/kirkwood/cpu.c | 41 > > ++++++++++++++++++++++++++++++ > > > arch/arm/include/asm/arch-kirkwood/cpu.h | 1 + > > > 2 files changed, 42 insertions(+), 0 deletions(-) > > > > > > > Please drop this patch. It's cosmetic, becoming a hassle to do > > properly, and doesn't move me towards my goal of mainline dreamplug > > support. > > Hi Jason > I think this is useful information to be displayed. > Thanks for your effort so far on this patch, and I wish that should not go > waste. > > You can think of supporting this once your dreamplug is supported :-)
Of course, I just found it was becoming very time consuming to do properly and taking time away from learning devicetree. Once dreamplug support is in, I'll readdress it. thx, Jason. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
