Yea it is around 3-4 years old now.... I investigated since it seemed to take longer than usual for my customer signals to recover after a good rain.... like a day or so.
*Jonathan Taylor* *WiSouth Networks, LLC* jtay...@wisouth.net *(334) 595-9521* On Sun, Sep 4, 2016 at 7:50 PM, Chris Fabien <ch...@lakenetmi.com> wrote: > I just took one of these apart like this. I suspected a problem but ours > was still operating fine. Some of the screws in the base had worked loose. > The elements are fed by short pieces of coax so the movement does not mean > a broken circuit board or connector or something. > > The faulire mode we typically have seen on these omnis is glue failure on > the cap, cap blows off and water gets into the antenna. It can drain out > the bottom but over time will corrode the elements and affect performance. > > With the price of these, i wpuld probably just replace it... its probably > several years old now right? > > On Sep 4, 2016 8:34 PM, "Jonathan Taylor" <jtay...@wisouth.net> wrote: > >> My AMO-2G13 wobles back and fourth at least an inch or two.... i can't >> pull up on it any but i can push it side to side. Should it do this? I >> don't recall it doing that when i installed it. >> And yes the mount does not move... it is the radome section that moves. >> Normally i would look at air control for history to see if the signal and >> ccq has gotten worse but my last AC2 update was botched a couple months ago >> and all my history is gone. >> >> >> >> *Jonathan Taylor* >> *WiSouth Networks, LLC* >> jtay...@wisouth.net >> *(334) 595-9521* >> >> _______________________________________________ >> Ubnt_users mailing list >> Ubnt_users@wispa.org >> http://lists.wispa.org/mailman/listinfo/ubnt_users >> >> > _______________________________________________ > Ubnt_users mailing list > Ubnt_users@wispa.org > http://lists.wispa.org/mailman/listinfo/ubnt_users > >
_______________________________________________ Ubnt_users mailing list Ubnt_users@wispa.org http://lists.wispa.org/mailman/listinfo/ubnt_users
