Interesting enough, I just had a KPP omni blow it's top. I've had a few
UBNT's do it but this is the 1st KPP.

On Mon, Sep 5, 2016 at 12:25 PM, Mathew Howard <mat...@litewire.net> wrote:

> For 2.4ghz omnis, we mostly use ARC wireless (but not 5ghz version - those
> are junk). We've also used some that I believe are the same as the KPP's,
> but I don't remember what the brand is off hand (several companies sell the
> same antennas) for both 5ghz and 2.4ghz.
>
> ------------------------------
> *From:* ubnt_users-boun...@wispa.org [ubnt_users-boun...@wispa.org] on
> behalf of Jonathan Taylor [jtay...@wisouth.net]
> *Sent:* Sunday, September 04, 2016 9:15 PM
> *To:* Ubiquiti Users Group
> *Subject:* Re: [Ubnt_users] Bad Omni???
>
> Which antennas do you use?
>
> *Jonathan Taylor*
> *WiSouth Networks, LLC*
> jtay...@wisouth.net
> *(334) 595-9521*
>
> On Sun, Sep 4, 2016 at 8:46 PM, Mathew Howard <mat...@litewire.net> wrote:
>
>> Yeah... I would replace it. You might be able to just take it apart and
>> re-glue everything, but it's probably really not worth while.
>>
>> I only remember having a similar failure on one, which also had the top
>> cap come off - which I think is what caused the glue to fail, since the
>> drain holes plugged up and it had a lot of water sitting in it. We haven't
>> been using UBNT omnis for the last few years anyway, because there are
>> cheaper alternatives that seem to be higher quality.
>>
>> ------------------------------
>> *From:* ubnt_users-boun...@wispa.org [ubnt_users-boun...@wispa.org] on
>> behalf of Josh Luthman [j...@imaginenetworksllc.com]
>> *Sent:* Sunday, September 04, 2016 8:17 PM
>> *To:* Ubiquiti Users Group
>> *Subject:* Re: [Ubnt_users] Bad Omni???
>>
>> If a rain effects things like that in 2 GHz it's well past time to
>> replace that thing.
>>
>>
>> Josh Luthman
>> Office: 937-552-2340
>> Direct: 937-552-2343
>> 1100 Wayne St
>> Suite 1337
>> Troy, OH 45373
>>
>> On Sun, Sep 4, 2016 at 9:15 PM, Jonathan Taylor <jtay...@wisouth.net>
>> wrote:
>>
>>> Yea it is around 3-4  years old now.... I investigated since it seemed
>>> to take longer than usual for my customer signals to recover after a good
>>> rain.... like a day or so.
>>>
>>> *Jonathan Taylor*
>>> *WiSouth Networks, LLC*
>>> jtay...@wisouth.net
>>> *(334) 595-9521*
>>>
>>> On Sun, Sep 4, 2016 at 7:50 PM, Chris Fabien <ch...@lakenetmi.com>
>>> wrote:
>>>
>>>> I just took one of these apart like this. I suspected a problem but
>>>> ours was still operating fine. Some of the screws in the base had worked
>>>> loose. The elements are fed by short pieces of coax so the movement does
>>>> not mean a broken circuit board or connector or something.
>>>>
>>>> The faulire mode we typically have seen on these omnis is glue failure
>>>> on the cap, cap blows off and water gets into the antenna. It can drain out
>>>> the bottom but over time will corrode the elements and affect performance.
>>>>
>>>> With the price of these, i wpuld probably just replace it... its
>>>> probably several years old now right?
>>>>
>>>> On Sep 4, 2016 8:34 PM, "Jonathan Taylor" <jtay...@wisouth.net> wrote:
>>>>
>>>>> My AMO-2G13 wobles back and fourth at least an inch or two.... i can't
>>>>> pull up on it any but i can push it side to side.  Should it do this?  I
>>>>> don't recall it doing that when i installed it.
>>>>> And yes the mount does not move... it is the radome section that
>>>>> moves.  Normally i would look at air control for history to see if the
>>>>> signal and ccq has gotten worse but my last AC2 update was botched a 
>>>>> couple
>>>>> months ago and all my history is gone.
>>>>>
>>>>>
>>>>>
>>>>> *Jonathan Taylor*
>>>>> *WiSouth Networks, LLC*
>>>>> jtay...@wisouth.net
>>>>> *(334) 595-9521*
>>>>>
>>>>> _______________________________________________
>>>>> Ubnt_users mailing list
>>>>> Ubnt_users@wispa.org
>>>>> http://lists.wispa.org/mailman/listinfo/ubnt_users
>>>>>
>>>>>
>>>> _______________________________________________
>>>> Ubnt_users mailing list
>>>> Ubnt_users@wispa.org
>>>> http://lists.wispa.org/mailman/listinfo/ubnt_users
>>>>
>>>>
>>>
>>> _______________________________________________
>>> Ubnt_users mailing list
>>> Ubnt_users@wispa.org
>>> http://lists.wispa.org/mailman/listinfo/ubnt_users
>>>
>>>
>>
>> _______________________________________________
>> Ubnt_users mailing list
>> Ubnt_users@wispa.org
>> http://lists.wispa.org/mailman/listinfo/ubnt_users
>>
>>
>
> _______________________________________________
> Ubnt_users mailing list
> Ubnt_users@wispa.org
> http://lists.wispa.org/mailman/listinfo/ubnt_users
>
>


-- 
-RickG KyWiFi
_______________________________________________
Ubnt_users mailing list
Ubnt_users@wispa.org
http://lists.wispa.org/mailman/listinfo/ubnt_users

Reply via email to