We have them as CPEs, PtPs. PtP 3 mile in noisy area getting 50Mbps. -65
sig -87 NF

On Fri, Oct 7, 2016 at 1:05 AM, Nathan Babcock <[email protected]>
wrote:

> I have never had good luck with them.  We ended up giving ours away to
> anyone who would take them and just stopped buying them altogether.
>
>
>
> *From:* [email protected] [mailto:[email protected]]
> *On Behalf Of *Phil Curnutt
> *Sent:* Thursday, October 6, 2016 3:39 PM
> *To:* Ubiquiti Users Group <[email protected]>
> *Subject:* [Ubnt_users] NanoBeam 5AC-19's and PowerBeam 5AC-300's
>
>
>
> I had a short back bone link from one small AP to another so used a pair
> of NBE-5AC-19's expecting an Rx of around -55.  After connecting the link
> the best we could get was a -66 on Chain0 and a -77 on Chain1 when the
> radios were at the proper tilt and azimuth.  With help from the Alignment
> Tool we got it down to a -60/-70, but AP end of the link was aimed about 5
> degree down rather then 1 degree up.  We could achieve the same Chain0,
> Chain1 imbalance the other way with the AP aimed 1 degree up and the
> Station aimed 6 degrees down.  I replace the Station end with a PBE-5AC-300
> and dropped the Chain0/Chain1 signals to -60/-70, but no better.  So, today
> I replace the AP end with another 300 and the signal dropped to -47/-47.
>
>
>
> So, the question is has anyone else seen this behavior in the NanoBeam?
> We have a bunch of them in use on PtMP AP's using sectors and they work
> just as expected, but when used as PtP this weird astigmatism shows up.
>
>
>
> Phil
>
> _______________________________________________
> Ubnt_users mailing list
> [email protected]
> http://lists.wispa.org/mailman/listinfo/ubnt_users
>
>


-- 


-- 
Clay Stewart, COO/CTO
SCS Broadband
A Division of Acelanet, LLC
  434.263.6363 O
  434.942.6510 C
  [email protected]
“We Keep You Up and Running”

Please send sales inquiries to [email protected]
Please send service/repair requests to [email protected]
_______________________________________________
Ubnt_users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/ubnt_users

Reply via email to