JackOfAll wrote: > dsdreamer (Charles), do you use hdmi audio? If you do, can you test a > F20 kernel? > > > Code: -------------------- > > > sudo csos-cleanUpdate-testing kernel > -------------------- > > > > > > Questions are.... With a hdmi device being plugged in from boot..... > > 1. Video still works? > 2. Does it work any better than it did before, vis-a-vis EDID > detection code. (ISTR you had to set params on kernel cmd line.) > 3. Does /dev/fb0 get created? > 4. Do you get a hdmi audio device listed? (aplay -l) > 5. Does the hdmi audio device actually work? ;) > > PS. If you do try running, don't forget to correct the dtb entry in > /boot/extlinux/extlinux.conf before you run it. The dtb file has > definitely changed 3.13.x -> 3.14.0.rcx).
Hallo Clive, I installed kernel 3.14-xxx with a hdmi device connected at boot-up. Your Questions: 1. No 2. No 3. No 4. No 5. No But I started with the minimal system without graphical support and was not succesful up to now to enable graphical.target - but is was not my major task. Perhaps You can give me a hint about this. The kernel itself works good, the brcmfmac driver show a new kind of messages: brcmfmac: brcmf_construct_reginfo: channel 1: f=2412 bw=0 sb=-339985652 but works. Bernd ------------------------------------------------------------------------ ab.wagener's Profile: http://forums.slimdevices.com/member.php?userid=53748 View this thread: http://forums.slimdevices.com/showthread.php?t=99395 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
