Am 03.12.2014 15:00, schrieb Peter Klügl: > Unfortunately, the builder overrides the extensions with the provided > ones in the workbench. > > I can change this if you want. However, it would also be reasonable to > investigate why the extension is not added anyway...
Was just a minimal change. If you work on the current trunk, you can give it a try. Best, Peter > Best, > > Peter > > Am 02.12.2014 16:57, schrieb Peter Klügl: >> Hmmm, I have to check it (tomorrow) ... >> >> Am 02.12.2014 16:53, schrieb Silvestre Losada: >>> I have it in descriptor folder however ruta workbench is not using that >>> file. would it be possible that ruta workbench has another one? >>> >>> >>> Regards >>> >>> On 2 December 2014 at 16:24, Peter Klügl <[email protected]> wrote: >>> >>>> should be in the descriptor folder of the ruta project >>>> >>>> Peter >>>> >>>> Am 02.12.2014 16:03, schrieb Silvestre Losada: >>>>> Hi Peter, >>>>> >>>>> Could you tell me where is located BasicEngine.xml templated? >>>>> >>>>> Thanks in advance. >>>>> >>>>> On 2 December 2014 at 13:42, Peter Klügl <[email protected]> >>>> wrote: >>>>>> Hi, >>>>>> >>>>>> there are two types of extension, one for the analysis engine and one >>>>>> for the workbench. >>>>>> The second takes care that the descriptor contain references to the >>>>>> first one. >>>>>> >>>>>> Provides the editor syntax highlighting for your new action? >>>>>> >>>>>> Do you have a plugin in the workbench that provides an Eclipse extension >>>>>> for the extension point org.apache.uima.ruta.ide.actionExtension? >>>>>> I wonder why the extension is part of the classpath at all if the >>>>>> configuration parameters are not updated. >>>>>> >>>>>> The descriptors are replaced when the script file is saved. There is no >>>>>> direct way to avoid the overwriting. If you do not want to take care of >>>>>> the Workbench stuff at all, you could probably also just add the >>>>>> extension to the BasicEngine.xml (it's the template for the descriptors) >>>>>> >>>>>> >>>>>> Best, >>>>>> >>>>>> Peter >>>>>> >>>>>> >>>>>> >>>>>> Am 02.12.2014 13:15, schrieb Silvestre Losada: >>>>>>> I created new UIMA action using the languages extension >>>>>>> < >>>> https://uima.apache.org/d/ruta-current/tools.ruta.book.html#ugr.tools.ruta.language.extensions >>>>>>> , >>>>>>> In file descriptor generated by ruta workbench I had to added to >>>>>>> configuration parameters in additiionalExtensions section. The >>>> extension >>>>>> is >>>>>>> working properly, however ruta workbench overwrites the file descriptor >>>>>>> sometimes and I loose that configuration. Is there any way to >>>> configure >>>>>>> Ruta workbench to avoid overwriting the file descriptor? >>>>>>> >>>>>>> Kind regards >>>>>>>
