12.02.2018 16:15, Klaus Wenninger пишет:
On 02/12/2018 01:02 PM, Maxim  wrote:
> fencing-disabled is probably due to it being a test-setup ... RHEL 6
> pcs being made for configuring a cman-pacemaker-setup I'm not sure if
> it is advisable to do a setup for a corosync-2 pacemaker setup with
> that. You've obviously edited corosync.conf to reflect that ...
It is ok. Fencing is not required at the time.
It works well with latest stable corosync and pacemaker that were built manually (not from RHEL 6 repos). And the attached config was generated by this pcs (i've removed 'logging' section from there to decrease a message size).



>>
>> All is ok mainly. But there is some problem of the cluster
>> activity performance when the master node is powered off (hard):
>> the slave node detects that the master one is down after about
>> 100-3500 ms. And the main question is how to avoid this 3 sec delay
>> that occurred sometimes.
>
> Kind of interesting that you ever get a detection below 2000ms with
> the token-timeout set to that value. (Given you are doing a
> hard-shutdown that doesn't give corosync time to sign off.) You've
> derived these times from the corosync-logs!?
>
> Regards, Klaus
>
Not actually. After your message i've conduct some more investigations with quite active logging on the master node to get the real time when node is going down. And... you are right. The delay is close to 4 seconds. So there is a [foating] bug in my script.
Thank you for your inside, Klaus =)

Butneverthelessis there any mechanism to force the slave corosync "to think" that the master corosync is down? [I have seen the abilities of corosync-cfgtools but, seems, it doesn't contain similar functionality]
Or maybe are there some another ways?

Regards, Maxim


_______________________________________________
Users mailing list: Users@clusterlabs.org
http://lists.clusterlabs.org/mailman/listinfo/users

Project Home: http://www.clusterlabs.org
Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
Bugs: http://bugs.clusterlabs.org

Reply via email to