Drew Jensen wrote:
Juraj Trenkler wrote:
Dňa Friday 29 February 2008 Drew Jensen napísal:
Juraj Trenkler wrote:
OOH m8 works fine. Both macros and report editing.
juraj
OK - well it is still a problem here.
I removed DEV0300 completely.
Installed 2.4 RC2 downloaded today.
.....
If I take OpenOffice.org completely out of memory, open the ODT file -
everthing works.
Then open the Base file, then all the embedded forms work as expected.
Yes.
(OpenSuse 10.3, OOoH m8 slovak.)
If I start OOo running "sbase" with opening odb file and open
embedded form, macros do not work. When I close the odb file and
open it again (without closing OOo) macros work.
I tried to open OOo running "scalc" or "soffice" or "swriter" and
then open odb file. Macros work fine immediately.
So it seems that it is not good idea to start OOo as "sbase" if you
want to work with base file. Than you have to close odb file and open
it again.
juraj
Thanks for letting me know.
I'll be trying this later on with 2.4 RC2 ( m8 Build 9276 ) later
today on Kubutnu 7.1 (32 bit ) but it sounds like I'll find the same
thing there.
Also - I noticed that you where saying it a little different and you
where correct. The controlling factor is not the ODT file ( with a
dataform ) opening first rather which module opens first. A bland writer
file works just as well. That may important for them to find the cause.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
