This is a perfect situation for 6to4. Just use your static IPv4 address to
create a /48 IPv6 prefix for your home.
Rich
> -----Original Message-----
> From: Sriranga Veeraraghavan [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, October 05, 2000 6:03 PM
> To: [EMAIL PROTECTED]
> Cc: [EMAIL PROTECTED]
> Subject: IPv6 Setup Questions
>
>
>
> Hi,
>
> I would like to get my systems at home connected to the 6bone, and I
> have a few questions about how to proceed.
>
> I have a single static IP address and I'm using NAT to "share" it with
> my other systems:
>
> Internet
> |
> | (static IP)
> OpenBSD NAT
> | (192.168.0.2)
> |
> +===========+===============+
> FreeBSD Linux
> (192.168.0.3) (192.168.0.4)
>
> I went to www.freenet6.net and used the configuration information
> their script supplied to configure an IPv6 tunnel from my OpenBSD NAT
> system to thier system. I was able to get this working; I can ping6
> and traceroute6 to systems with IPv6 only addresses.
>
> Now I want to connect my other machines (the IPv6 capable ones with
> private IPv4 addresses) to the 6bone as well.
>
> My understanding is that even though I use NAT and have only have one
> static IPv4 address I should still be able to conect these systems to
> the 6bone. But I can't seem to find any info on how to accomplish
> this.
>
> Do I have to contact a upstream provider and ask for a tunnel and a
> block IPv6 addresses?
>
> If so, whom should I ask?
>
> Can I just share the tunnel I have now (perhaps using the IPv6
> equivalent of NAT, if it exists)?
>
> I would appreciate any pointers.
>
> Thanks,
>
> ----ranga
>
>
> ---------------------------------------------------------------------
> The IPv6 Users Mailing List
> Unsubscribe by sending "unsubscribe users" to [EMAIL PROTECTED]
>
---------------------------------------------------------------------
The IPv6 Users Mailing List
Unsubscribe by sending "unsubscribe users" to [EMAIL PROTECTED]
