I don't quite understant your architecture. Why would you need more than one SMSbox?
On 9/2/07, lekkie <[EMAIL PROTECTED]> wrote: > > Thanks for your reply. > I ve gone thru the doc. > So, if I want to set up multiple SMSBox, how do I do that. > I tried setting up two SMSBoxes my make two SMSBox config file and assigning > different sms-port numbers to them, but it was only the second SMSBox that > was up. > How do I do this? > > Thanks once again. > > > Rodrigo Cremaschi wrote: > > > > YES, it is possible. > > PLEASE, take some time to read the userguide AND the following document: > > http://www.kannel.org/download/1.3.2/arch-1.3.2/arch.html > > Many of the terms defined there apply also to SMS. > > Then, come back with any problems that may araise. > > Regards, > > R. > > > > On 8/31/07, lekkie <[EMAIL PROTECTED]> wrote: > >> > >> Please, I need a help here. > >> > >> I want to to be able to receive message from a telco's SMPP SMSC and only > >> pass it to a url. > >> I also need another SMPP SMSC that will only deliver mesage to the same > >> telco. > >> > >> Is this possible? > >> > >> > >> lekkie wrote: > >> > > >> > Hi, > >> > > >> > Below is my config file. > >> > > >> > However, what'd like is a single HTTP connection to an application to > >> send > >> > and receive SMS from the application > >> > > >> > > >> > I'd also like 3 links to 3 telcos over SMPP binding as transceivers, so > >> > that they can receive and send messages. > >> > > >> > How can I make sure a message coming from a telco SMSC link will be > >> > forwarded to another SMSC or to a URL. > >> > I also want to be able to receive message from this application and > >> > forward it to an SMSC. (This I can do my specifying the user) > >> > > >> > Thanks. > >> > > >> > group = core > >> > admin-port = 13000 > >> > smsbox-port = 13001 > >> > admin-password = password > >> > #status-password = password > >> > admin-allow-ip = 127.0.0.1 > >> > log-file = "/var/smsgateway/log/kannel.log" > >> > log-level = 0 > >> > box-deny-ip = "*.*.*.*" > >> > box-allow-ip = 127.0.0.1 > >> > unified-prefix = "+234,0" > >> > access-log = "/var/smsgateway/log/access.log" > >> > #store-file = "/var/smsgateway/kannel/kannel.store" > >> > > >> > > >> > group = smsc > >> > smsc = smpp > >> > host = [telco-ip] > >> > port = [telco-port] > >> > receive-port = [same-port-as-above] > >> > transceiver-mode = true > >> > smsc-id = TelcoSmppLink > >> > smsc-username = uname > >> > smsc-password = pword > >> > system-type = [system-type] > >> > service-type = smpp > >> > allowed-prefix = +234803;+234806;+234703;0803;0806;0703 > >> > denied-prefix = * > >> > unified-prefix = "+234,0,234" > >> > log-file = "/var/smsgateway/log/kannel.log" > >> > log-level = 0 > >> > address-range = 0 > >> > connect-allow-ip = "127.0.0.1;[telco-ip]" > >> > > >> > > >> > # SMSC Link to send SMS to app > >> > group = smsc > >> > smsc = http > >> > port = 0 > >> > smsc-id = HttpLinkToApp > >> > system-type = kannel > >> > smsc-username = http > >> > smsc-password = http > >> > send-url = > >> > > >> "http://[app-server-ip]/app/smexpress?smsvendor=kannel&from=%P&to=%p&text=%b&id=%I"; > >> > allowed-prefix = > >> > > >> "+234803;+234806;+234703;0803;0806;0703;+234805;+234807;0805;0807;+234802;+234808;0802;0808" > >> > denied-prefix = * > >> > preferred-smsc-id = HttpLinkToApp > >> > unified-prefix = "+234,0,234" > >> > log-file = "/var/smsgateway/log/kannel.log" > >> > log-level = 0 > >> > address-range = 0 > >> > connect-allow-ip = "127.0.0.1" > >> > > >> > > >> > # SMSC Link to receive SMS from app > >> > group = smsc > >> > smsc = http > >> > port = 8080 > >> > smsc-id = HttpLinkFromPayphone > >> > system-type = kannel > >> > smsc-username = http > >> > smsc-password = http > >> > send-url = > >> > > >> "http://localhost:13013/cgi-bin/sendsms?username=telco&password=telco&from=AppName&to=%p&text=%b"; > >> > allowed-prefix = "+234803;+234806;+234703;0803;0806;0703" > >> > denied-prefix = * > >> > preferred-smsc-id = HttpLinkFromApp > >> > unified-prefix = "+234,0,234" > >> > log-file = "/var/smsgateway/log/kannel.log" > >> > log-level = 0 > >> > address-range = 0 > >> > connect-allow-ip = "127.0.0.1;[app-server-ip]" > >> > > >> > > >> > group = smsbox > >> > smsbox-id = LinktoTelcoSMSBox > >> > bearerbox-host = "127.0.0.1" > >> > sendsms-port = 13013 > >> > global-sender = "App" > >> > #sendsms-chars = "0123456789 +-" > >> > log-file = "/var/smsgateway/log/smsbox.log" > >> > log-level = 0 > >> > access-log = "/var/smsgateway/log/access.log" > >> > > >> > > >> > group = smsbox > >> > smsbox-id = LinktoAppNameSMSBox > >> > bearerbox-host = "172.16.10.249" > >> > sendsms-port = 13013 > >> > global-sender = "App" > >> > #sendsms-chars = "0123456789 +-" > >> > log-file = "/var/smsgateway/log/smsbox.log" > >> > log-level = 0 > >> > access-log = "/var/smsgateway/log/access.log > >> > > >> > > >> > group = smsbox-route > >> > smsbox-id = LinktoTelcoSMSBox > >> > smsc-ids = TelcoSmppLink > >> > > >> > > >> > # SEND-SMS USERS > >> > group = sendsms-user > >> > username = mtn > >> > password = mtn > >> > forced-smsc = TelcoSmppLink > >> > allowed-prefix = "+234803;+234806;+234703;0803;0806;0703" > >> > #user-deny-ip = "" > >> > #user-allow-ip = "" > >> > > >> > > >> > # SEND-SMS USERS > >> > group = sendsms-user > >> > username = appname > >> > password = appname > >> > forced-smsc = SmscToApp > >> > allowed-prefix = > >> > > >> "+234803;+234806;+234703;0803;0806;0703;+234805;+234807;0805;0807;+234802;+234808;0802;0808" > >> > #user-deny-ip = "" > >> > #user-allow-ip = "" > >> > > >> > > >> > > >> > > >> > > >> > > >> > Rodrigo Cremaschi wrote: > >> >> > >> >> Hi Lekkie, > >> >> > >> >> Tell us what have you done so far, and what problems have you > >> >> encountered. If you talked to the the carrier guys, what did they say? > >> >> So we can find out if Kannel, or the connection, or the SMSC has any > >> >> kind of problem. > >> >> > >> >> Regards, > >> >> Rodrigo. > >> >> > >> >> On 8/31/07, lekkie <[EMAIL PROTECTED]> wrote: > >> >>> > >> >>> How do I route incoming messages from SMPP Link? > >> >>> > >> >>> > >> >>> Rodrigo Cremaschi wrote: > >> >>> > > >> >>> > In that case, you must declare "transceiver-mode" variable to > >> "true". > >> >>> > Omit "receive-port" variable. > >> >>> > > >> >>> > Check the userguide, under SMPP 3.4 section. > >> >>> > > >> >>> > Regards. > >> >>> > > >> >>> > On 8/29/07, lekkie omotayo <[EMAIL PROTECTED]> wrote: > >> >>> >> Thanks for quick response. > >> >>> >> > >> >>> >> Yes, they have transceiver. > >> >>> >> > >> >>> >> If the operator has a transceiver connection, how can I can get > >> the > >> >>> >> inbound > >> >>> >> messages from my operator? > >> >>> >> How to I set up the config? > >> >>> >> > >> >>> >> What if my operator only supports transmitter/Receiver connection? > >> >>> >> > >> >>> >> Kind regards, > >> >>> >> > >> >>> >> Lekkie > >> >>> >> > >> >>> >> > >> >>> >> On 8/29/07, Rodrigo Cremaschi <[EMAIL PROTECTED]> wrote: > >> >>> >> > > Could this be because of the kannel version I am using > >> (1.4.1)? > >> >>> >> > No > >> >>> >> > > >> >>> >> > > Is it possible to receive SMS on SMPP connection? > >> >>> >> > Yes, that's what Kannel is for. > >> >>> >> > > >> >>> >> > Are you sure your operator needs 2 connetcions Tx and Rx? Or is > >> it > >> >>> a > >> >>> >> > transceiver? > >> >>> >> > > >> >>> >> > On 8/29/07, lekkie <[EMAIL PROTECTED] > wrote: > >> >>> >> > > > >> >>> >> > > Hi guys, > >> >>> >> > > > >> >>> >> > > I am trying to connect kannel to my mobile operator through an > >> >>> SMPP > >> >>> >> > > connection. > >> >>> >> > > > >> >>> >> > > However, my kannel box seem not to be listening on the > >> receiver > >> >>> port > >> >>> >> I > >> >>> >> > > specified. It ws able to connect to my operator on the > >> >>> transmitter > >> >>> >> port, > >> >>> >> but > >> >>> >> > > it never listen on the specified receive-port. > >> >>> >> > > > >> >>> >> > > With some googling, I found out, I can only get a receiver > >> >>> connection > >> >>> >> by > >> >>> >> > > creating two separate SMSC configs using one as a transmitter > >> the > >> >>> >> other > >> >>> >> as a > >> >>> >> > > receiver. I was advised to set transceiver mode to "no", set > >> the > >> >>> >> > > receive-port option to 0 (set transmit port) if I want to > >> >>> transmit > >> >>> >> and > >> >>> >> set > >> >>> >> > > transmit port to 0 if I want to receive (set receive port to > >> >>> 2001). > >> >>> >> When > >> >>> >> I > >> >>> >> > > did this, the log file told me I had a receiver bind however, > >> >>> kannel > >> >>> >> > > connects to the operator's SMSC on the receiver port even > >> though > >> >>> >> transmitter > >> >>> >> > > port is set to 0. > >> >>> >> > > > >> >>> >> > > > >> >>> >> > > However, when I tried setting both port to same port, I ended > >> up > >> >>> >> having > >> >>> >> two > >> >>> >> > > connections to SMSC both connection to the operator's port > >> while > >> >>> >> source > >> >>> >> port > >> >>> >> > > was not open > >> >>> >> > > > >> >>> >> > > However, when I tried setting both port to diff port, I ended > >> up > >> >>> >> having > >> >>> >> one > >> >>> >> > > connection to SMSC. > >> >>> >> > > > >> >>> >> > > I am afraid my config file may be wrong. > >> >>> >> > > > >> >>> >> > > Is there a way I can do this. > >> >>> >> > > > >> >>> >> > > Do I need 1 smsc config to achieve both transmitter and > >> receiver > >> >>> >> connection? > >> >>> >> > > Do I need 1 smsbox config to achieve both transmitter and > >> >>> receiver > >> >>> >> > > connection? > >> >>> >> > > > >> >>> >> > > Could this be because of the kannel version I am using ( > >> 1.4.1)? > >> >>> >> > > > >> >>> >> > > Is it possible to receive SMS on SMPP connection? > >> >>> >> > > > >> >>> >> > > Thanks. > >> >>> >> > > > >> >>> >> > > > >> >>> >> > > -- > >> >>> >> > > View this message in context: > >> >>> >> > >> >>> > >> http://www.nabble.com/How-to-receive-MO-on-an-SMPP-link-tf4350019.html#a12394561 > >> >>> >> > > Sent from the Kannel - User mailing list archive at > >> Nabble.com. > >> >>> >> > > > >> >>> >> > > > >> >>> >> > > > >> >>> >> > > >> >>> >> > >> >>> >> > >> >>> > > >> >>> > > >> >>> > > >> >>> > >> >>> -- > >> >>> View this message in context: > >> >>> > >> http://www.nabble.com/How-to-receive-MO-on-an-SMPP-link-tf4350019.html#a12426727 > >> >>> Sent from the Kannel - User mailing list archive at Nabble.com. > >> >>> > >> >>> > >> >>> > >> >> > >> >> > >> >> > >> > > >> > > >> > >> -- > >> View this message in context: > >> http://www.nabble.com/How-to-receive-MO-on-an-SMPP-link-tf4350019.html#a12433703 > >> Sent from the Kannel - User mailing list archive at Nabble.com. > >> > >> > >> > > > > > > > > -- > View this message in context: > http://www.nabble.com/How-to-receive-MO-on-an-SMPP-link-tf4350019.html#a12449107 > Sent from the Kannel - User mailing list archive at Nabble.com. > > >
