Hi Calixte,
I would rather not, because there is no other problem with the Linux
driver and I remember other problems with the proprietary driver
(besides that it is proprietary ...). And why is the figure OK if
there is an error in the driver? It is only after the export that the
error shows up!
/Stefan
On 2014-01-13 10:52, Calixte Denizet wrote:
--------------------
Weird... imho it is a problem with the driver of your GC.
Could you try to install proprietary driver please ?
Regards
Calixte
On 13/01/2014 10:50, Stefan Du Rietz wrote:
Hi Calixte,
here you are!
Regards /Stefan
On 2014-01-13 10:43, Calixte Denizet wrote:
--------------------
Hi Stefan,
Could you attach the guilty picture please ?
Regards
Calixte
On 13/01/2014 10:37, Stefan Du Rietz wrote:
On 2014-01-13 09:16, Antoine Monmayrant wrote:
--------------------
On 01/13/2014 01:27 AM, Stefan Du Rietz wrote:
Hi,
when I export a figure to a bitmap file (PNG, JPG, GIF, PPM, BMP)
from Xubuntu Linux, it has the y axis turned about 30 degrees
clockwise and is divided in two parts. Has anybody else experienced
that?
Regards /Stefan
_______________________________________________
users mailing list
[email protected]
http://lists.scilab.org/mailman/listinfo/users
Hi Stefan,
Could you send us a small test script that produces the bogus
plot, so
we can give it a try?
Do you have a huge scaling factor between x and y?
Like mean(y)<mean(x)*10^-4 ?
If it is the case, try plot(x,y*10^4) (replacing 10^4 be the inverse
of the y/x ratio).
There use to be a bug that produces this slant, but it is corrected
now: see http://bugzilla.scilab.org/show_bug.cgi?id=11399 .
Hope it helps,
Antoine
_______________________________________________
users mailing list
[email protected]
http://lists.scilab.org/mailman/listinfo/users
Hi Antoine,
there is nothing wrong with the plot, only with the exported file!
And even that is OK when exported from Windows 7.
x = [0:0.05*%pi:2*%pi]';
f = scf();
plot2d(x, sin(x))
xgrid()
Now, from the figure menu: File > Export to ... > PNG (or any other)
File > Vectorial export ... works OK.
Regards /Stefan
_______________________________________________
users mailing list
[email protected]
http://lists.scilab.org/mailman/listinfo/users
_______________________________________________
users mailing list
[email protected]
http://lists.scilab.org/mailman/listinfo/users
--
Calixte Denizet
Software Development Engineer
-----------------------------------------------------------
Scilab Enterprises
143bis rue Yves Le Coz - 78000 Versailles, France
http://www.scilab-enterprises.com
_______________________________________________
users mailing list
[email protected]
http://lists.scilab.org/mailman/listinfo/users
_______________________________________________
users mailing list
[email protected]
http://lists.scilab.org/mailman/listinfo/users
