I have an E310 (sg3) that I need to enable the CAN controller on and route the signals out to the GPIO connector. After that, I'll work on the Linux driver.
I'm a newbie to Vivado, so I could use some detailed help. What I've done so far: - Built an Ubuntu 18.04 system - Installed Vivado 2018.3.1 - Downloaded the EttusResearch/fpga.git repo - Tested "make E310_sg3" both with and without the "GUI=1" setting. I tried going in to Vivado and enabling the CAN0 controller, but I wasn't able to figure out how to rebuild the design (or route the signals to the GPIO connector) Any help would be appreciated. Rich
_______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
