On 04/12/2021 12:48 PM, Rich Gopstein wrote:
Can anyone offer any suggestions? I've been digging through TCL files
looking for where I could enable the CAN0 controller, but nothing has
worked so far.
Thanks.
Rich
I'll point out that USB-to-CAN adapters aren't that expensive. Might be
a more-immediately-productive route.
On Tue, Apr 6, 2021 at 10:00 AM Rich Gopstein <[email protected]
<mailto:[email protected]>> wrote:
I have an E310 (sg3) that I need to enable the CAN controller on
and route the signals out to the GPIO connector. After that, I'll
work on the Linux driver.
I'm a newbie to Vivado, so I could use some detailed help. What
I've done so far:
* Built an Ubuntu 18.04 system
* Installed Vivado 2018.3.1
* Downloaded the EttusResearch/fpga.git repo
* Tested "make E310_sg3" both with and without the "GUI=1" setting.
I tried going in to Vivado and enabling the CAN0 controller, but I
wasn't able to figure out how to rebuild the design (or route the
signals to the GPIO connector)
Any help would be appreciated.
Rich
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
