Can anyone offer any suggestions? I've been digging through TCL files looking for where I could enable the CAN0 controller, but nothing has worked so far.
Thanks. Rich On Tue, Apr 6, 2021 at 10:00 AM Rich Gopstein <[email protected]> wrote: > I have an E310 (sg3) that I need to enable the CAN controller on and route > the signals out to the GPIO connector. After that, I'll work on the Linux > driver. > > I'm a newbie to Vivado, so I could use some detailed help. What I've done > so far: > > - Built an Ubuntu 18.04 system > - Installed Vivado 2018.3.1 > - Downloaded the EttusResearch/fpga.git repo > - Tested "make E310_sg3" both with and without the "GUI=1" setting. > > > I tried going in to Vivado and enabling the CAN0 controller, but I wasn't > able to figure out how to rebuild the design (or route the signals to the > GPIO connector) > > Any help would be appreciated. > > Rich > >
_______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
