on 5/22/00 4:20 PM, TC at [EMAIL PROTECTED] wrote:
> Phil,
> Sounds like you ended up running a much taller tire, (rolling
> diameter), than stock ...if you are turning 3500 at 60 mph and they
> retained the same primary gearing 87/47 on the crank snout/clutch
> basket, (no reason they shouldn't have), and your front chain gear has
> 13 teeth ... then you are running a tire with a 14.25 inch rolling
> diameter, (stock is 12.5). If you want to turn 3850 at 60 mph .. with
> this tire, (14.25 rolling diameter), and a 13 tooth chain gear up
> front then you will need a 43 tooth gear on the rear axle.
> campbell
>
Hey TC,
Unless Phil is really using that Huffy tire I recommended, isn't that
supposed to be radius rather than diameter?
Best,
Sat Tara
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
