on 6/8/00 10:38 AM, Wayne H pettipas at [EMAIL PROTECTED] wrote:
> Hello out there in Vmax land:
>
> I am in the middle of replacing my rear brake pads and have what I hope is a
> minor problem.
>
> Both cylinders were out different amounts when I removed the old pads.
perfectly normal
>
> One pad the right side compressed back into the body fairly easily using a
> small clamp. However the left side does not want to retract. It will move
> outwards so it not seized.
open the rear brake master reservoir, suck out a little fluid (so res.
doesn't overflow), leave top off and push in the caliper cylinder. Replace
fluid and cap when done.
>
> Solutions please. I was considering cracking the bleed screw to allow some
> fluid to be released.
That'll work also, but you'll need to bleed the system at the end.
>
> Regards
>
> Wayne
> #1266
best,
Sat Tara
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
