Don,
if taking "y" off made the thing worse,then you can be sure you
were having a Lean down just before getting on to the needles and not
producing the vac signal to pull the needles on open. did you try the bowl
vent tubes along with your changes?
steve #1131
>From: "Don Seel" <[EMAIL PROTECTED]>
>Reply-To: [EMAIL PROTECTED]
>To: V-MAX TECH LIST <[EMAIL PROTECTED]>
>Subject: re:re: stage 1 tuning assistance
>Date: Mon, 12 Jun 2000 09:43:05 -0700
>
>Thanks for all of the replies. I tried to run the bike with the Y removed.
>The problem got dramatically worse. I have now changed to DJ-165's mains,
>needles in #3 position, have always had a K+N filter, and installed DJ
>150's
>in PAJ-1 (once again as per Dynojet). The bike runs dramatically better
>(will now lift the front wheel during 1st gear roll on), but still bogs at
>low rpm under heavy load. I am going to call Dynojet for assistance and
>give them an opportunity to come clean before I start tackling the tuning
>on
>my own. I think during my phone call I will order the parts to perform the
>hybrid stage 1-7 that we've discussed in the past.
>
>Don Seel
>
>.............................................
>To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
>.............................................
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
