Thanks Don, Where do you get different size pilot jets at? Do you know the size to start at for these?(drill bit size-mm,in.) I have a numbered drill bit set, I bought it and have used it on many jet resizing adventures. I always make sure I know where to get new jets in case I go a little too large. I checked the contents of a Stage1 kit on Campbells' site. Doesn't seem like a lot of parts for $100. I'll also check the floats. Thanks for your help on this, I'm learning a new motorcycle, Gary ----- Original Message ----- From: "donald smith" <[EMAIL PROTECTED]> To: "V-MAX TECH LIST" <[EMAIL PROTECTED]> Sent: Thursday, November 30, 2000 12:06 AM Subject: Re: Part# Gary, don't waste your money. Unless your doing stage 7, then leave the stock needles in. 1st thing is to up the pilot jet size and make sure the floats are set the same. Even brand new, off the floor, they're not the same. Then you can start tuning. Do it right the 1st time and it won't cost as much and be better off. Don "Old Man" Smith ............................................. To unsubscribe go to http://www.sayegh.org/unsubscribe.htm ............................................. ............................................. To unsubscribe go to http://www.sayegh.org/unsubscribe.htm .............................................
