Chuck you might try rigging your shell in a drill press running a file on the edge to make it sharp. Try different speeds as you feed it through the foam. ----- Original Message ----- From: Chuck Alexander To: [email protected] Sent: Monday, May 07, 2007 2:39 PM Subject: [VFB] Cutting Open Cell Foam
Folks: I have some open cell foam ( guess that is what it's called as it is not as dense as craft foam, but less dense than Styrofoam, and IS pliable like the craft foam) that is about one inch thick. I was gonna try to cut some popper bodies with it, so I took a shell casing, hit it with a hammer. It cut the foam OK, but when I took the foam out of the shell casing and it uncompresses (if that is a word), it is tapered on one end.. Any suggestions would be greatly appreciated. Thanks, Chuck
