On Mon, Jan 17, 2022 at 02:15:55PM +0800, Jason Wang wrote: > > 在 2022/1/14 下午9:39, Michael S. Tsirkin 写道: > > The spec says (v1.1 4.1.4.5 ISR status capability): > > > > The VIRTIO_PCI_CAP_ISR_CFG capability refers to at least a single byte, > > which contains the 8bit ISR > > status field to be used for INT#x interrupt handling. > > > > and > > > > to avoid an extra access, simply reading this register resets it to 0 and > > causes the device to deassert the > > interrupt. > > In this way, driver read of ISR status causes the device to deassert an > > interrupt. > > > > See sections 4.1.5.3 and 4.1.5.4 for how this is used. > > > > and in 4.1.5.4 Notification of Device Configuration Changes > > > > it says: > > > > • If MSIX capability is disabled: > > 1. Set the second lower bit of the ISR Status field for the device. > > 2. Send the appropriate PCI interrupt for the device. > > > > If MSIX capability is enabled: > > 1. If config_msix_vector is not NO_VECTOR, request the appropriate MSIX > > interrupt message for > > the device, config_msix_vector sets the MSIX Table entry number. > > > > all of the above make it looks like VIRTIO_PCI_CAP_ISR_CFG capability is > > unused with MSIX. > > > > This was actually the way the spec was understood by > > Zhu Lingshan from Intel (Cc'd). > > > > However, looking at the conformance statements, one finds out this is > > not the case: > > > > 4.1.4.5.1 Device Requirements: ISR status capability > > > > > > The device MUST present at least one VIRTIO_PCI_CAP_ISR_CFG capability. > > The device MUST set the Device Configuration Interrupt bit in ISR status > > before sending a device configu > > ration change notification to the driver. > > If MSIX capability is disabled, the device MUST set the Queue Interrupt > > bit in ISR status before sending a > > virtqueue notification to the driver. > > > > which implies that the Device Configuration Interrupt bit is set > > unconditionally. > > > > > > > > It is unfortunate that it does not copy this requirement in more places, > > and that the non-conformance text is incomplete and does not > > mention the MSI-X usage at all. > > > > I propose to extend 4.1.4.5 ISR status capability and > > 4.1.5.4 Notification of Device Configuration Changes > > to mention the MSI use. > > > I wonder do we want > > 1) mandate ISR bit > > or > > 2) remove the ISR bit set for MSI mode? > > 1) is the current Qemu behavior but seems a little bit contradict with the > goal of MSI. > > Thanks > >
I think we want the ISR bit since otherwise we need to go read a ton of config space fields to check whether anything changed. -- MST --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
