I have suggested that palladium is a red herring. If the phenomena is a surface 
effect then the outer surface of the palladium or material X will have the 
greatest number of defects or surface-effect areas and it has been found that 
roughening the surface will increase the effect. So too, I speculate will 
loading a bulk sample of palladium to the point that you induce fatigue cracks 
which will appear first on the surface and propogate inward as the internal 
pressure within the sample builds up due to the loading with hydrogen. You 
could get the same effect by first stressing a sample of palladium with proteum 
to the point that it would have shown the heat effect had it been loaded with 
deuterium then unloading the proteum and reloading it with deuterium. If the 
phenomena is a surface effect it should show up almost immediately just as in 
the case with the codeposited palladium and deuterium. The heat phemonema has 
show up in so many different material combinations and conditions that there is 
some other governing parameter other than palladium material. Granted palladium 
being open to hydrogen would allow it to migrate into the intersticies a little 
faster but just breaking up the material into a powder could produce the 
necessary surface defects and porosity needed to allow the heat effect to show 
up.
  ----- Original Message ----- 
  From: Peter Gluck 
  To: [email protected] 
  Sent: Monday, August 20, 2012 12:23 PM
  Subject: Re: [Vo]:Dominguez ICCF17 abstract


  I am looking this paper with very mixed feelinga.
  Admiration for a great effort, however 5% success rate
  due to palladiumphilia can be described by two nasty Latin sayings- too:


  Errare humanum est, persverare diabolicum
  Parturiunt montes, nascetur ridiculus mus


  I am very sorry but Pd is not good despite...everything..
  Don't make the skeptics happy!


  Peter


  On Mon, Aug 20, 2012 at 10:00 PM, Akira Shirakawa <[email protected]> 
wrote:

    On 2012-08-20 20:46, Jed Rothwell wrote:


      *Anomalous Results in Fleischmann-Pons Type Electrochemical*

    [...]

    This should be the result of what was mentioned in the 2012 DARPA budget 
review:

    http://nextbigfuture.com/2012/07/darpa-nanotech-projects-nanoscale.html
    http://www.mail-archive.com/[email protected]/msg67364.html

    Cheers,
    S.A.







  -- 
  Dr. Peter Gluck
  Cluj, Romania
  http://egooutpeters.blogspot.com

Reply via email to