I wrote: "and where does that released latent heat GO?" To which Jeff replied: "It goes into colder water entering the ecat"
So, let me get this straight... The above statement is what you think is the most likely 'sink' for the heat energy released when a number of vapor particles give off some of that heat energy and condense into a microscopic (suspended) droplet? I think even JC would have a problem with that one... -Mark -----Original Message----- From: Jeff Driscoll [mailto:[email protected]] Sent: Tuesday, July 05, 2011 11:23 AM To: [email protected] Subject: Re: [Vo]:Analysis of e-Cat test by E. Storms It goes into colder water entering the ecat - but I contend that the following possibilites exist for fakery. 1. large slugs of water are spit through the black hose and down the drain 2. the water stays in the Ecat and never leaves it 3. the input water is not measured correctly intentionally (fraudulently) On Tue, Jul 5, 2011 at 2:13 PM, Mark Iverson <[email protected]> wrote: > Jeff wrote: > "...it can condense into microscopic droplets while giving up latent heat > (heat of vaporization)" > > Agreed, and where does that released latent heat GO? > > -Mark > > > -----Original Message----- > From: Jeff Driscoll [mailto:[email protected]] > Sent: Tuesday, July 05, 2011 10:37 AM > To: [email protected] > Subject: Re: [Vo]:Analysis of e-Cat test by E. Storms > > it leaves the surface as a gaseous form but then it can condense into > microscopic droplets while giving up latent heat (heat of > vaporization) > > what thermodynamic point was incorrect? > > On Tue, Jul 5, 2011 at 1:22 PM, Terry Blanton <[email protected]> wrote: >> On Tue, Jul 5, 2011 at 1:12 PM, Joshua Cude <[email protected]> wrote: >> >>> Steam can be wet. Live with it. >> >> Water cannot leave the surface of water. It must be in a gaseous >> form. Learn some thermodynamics, Cude. Each molecule that escapes >> the intermolecular forces takes with it that amount of kinetic energy. >> >> T >> >> > >
