Assuming the boiling is always happening at the same pressure, you can extend the horizontal line B-C to the temperature axis and treat that as the temperature of boiling. Wet steam is present only AT the temperature of boiling. As long as the temperature of the vapour is just above the boiling temperature then you can be sure it is dry steam, even if it is only a tenth of degree above the boiling temperature. Harry
From: Mark Iverson <zeropo...@charter.net> >To: vortex-l@eskimo.com >Sent: Tuesday, July 5, 2011 3:47:37 PM >Subject: [Vo]: Survey based on Steam Phase diagram... > > >Take a look at Fig. 2.2.3 (about 2/3rds of the way down the page) on this >website: >http://www.spiraxsarco.com/resources/steam-engineering-tutorials/steam-engineering-principles-and-he >at-transfer/what-is-steam.asp > >There is a very clear explanation below the Figure... > >This is the best reference and explanation I've seen so far... > >***************** >For all those who care to chime in, >I'd like to know where you think the >E-Cat is operating along the A-B-C-D >line segments? >Or NOT on any of those segments... >***************** > >-Mark > > > > >